SE Electronics Ribbon Large Ribbon Microphone

Its single ‘Figure of 8’ polar pattern is derived from an incredibly fine 2 micron Aluminium membrane. Packaged in a tough, aluminium flightcase and comes complete with shockmount.

£510.63 (ex vat)

code 30188

in stock

for expert advice, price beating, package deals or even just a chat - contact a DV Store

SE Electronics Ribbon Large Ribbon Microphone description:

The sE RIBBON is a beautiful piece of engineering. Its single ‘Figure of 8’ polar pattern is derived from an incredibly fine 2 micron Aluminium membrane. As such it has a higher-than-normal frequency roll-off (at around 7KHz), and greater sensitivity, producing a more open and natural sound than you’d expect form a ribbon mic. The RIBBON is ideally suited to recording Electric Guitar cabs, Overhead Drum micing, Brass and woodwind Instruments, String Sections and for Commercial Broadcast and Voice Over. It comes with a 10 year replacement capsule guarantee

The sE Ribbon brings the advantages of the smooth classic sound of a high quality hand crafted Ribbon microphone within the reach of more users.

Features:

The sE Ribbon is packaged in a tough, aluminium flightcase and comes complete with shockmount
1.8 Micron pure aluminum ribbon element
Large ribbon geometry design
Rare Earth Neodymium Magnet
VOX – Velocity Optimized Extension for superior sensitivity / output
Warranty includes 3 Ribbon replacements
Recommended for: Electric Guitar, Overhead Drum micing, Brass Instruments, Vocals, Horn Sections, Woodwind Instruments, String Sections, Broadcast

Specifications:

Operating Principle: Electrodynamic pressure gradient (velocity Microphone)
Polar Pattern: Figure-8
Transducer Element: 1.8-micron aluminum ribbon - 45mm/1.77" tall, 4.5mm/.177" wide
Magnets: Rare Earth Neodymium
Frequency Response: m30 -15,000 Hz +/- 3dB
Output Sensitivity: > -52 dBv Re. 1v/pa
Output Impedance: 300 Ohms
Rated Load Impedance: 300 Ohms
Maximum SPL: >135dB over rated frequency response (more over 1K…)
Powering: Not needed or recommended. Tolerant of properly wired phantom power through a good cable.
Output Connector: Male XLR 3 pin
Dimensions: 168mm L, 40mm W
Weight: 450g
Finish: Mesh grille: satin nickel, Body: matte gray

SE Electronics Ribbon Large Ribbon Microphone (code 30188)
Its single ‘Figure of 8’ polar pattern is derived from an incredibly fine 2 micron Aluminium membrane. Packaged in a tough, aluminium flightcase and comes complete with shockmount.
£510.63 (ex vat)

Ribbon Large Ribbon Microphone: related links